Publicité
Machine overruns!
After switching off, stay with the machine until the workpiece comes to a
standstill. Never stop the rotation by hand!
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before cleaning,
maintenance or repair work and secure it against unintentional reconnection.
16.1
Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
• Remove chips and dirt particles from the machine after each use with compressed air and a
soft brush.
• Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
(e.g. WD40 rust inhibitor).
16.2
Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
• Before each operation, check the perfect condition of the safety devices.
• Regularly check the perfect and legible condition of the warning and safety labels of the
machine.
• Use only original spare parts recommended by the manufacturer.
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
before starting
work
after 50 operating
hours
HOLZMANN MASCHINEN GmbH
C A U T I O N
W A R N I N G
Component
• guide paths
• centre punch tip
and spur center
• motor
• cable connection
• turning tool
• drive belt
• carbon brushes
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O T E
• oil
• Keep the tool, especially the thread cone, free of
dust and apply a thin layer of oil.
• Check that the ventilation slots are free of
contamination.
• Check, replace if damaged.
• Check for defects and sharpness; sharpen or
replace if necessary.
• Check for tight fit and defects (e.g. cracks); replace
if necessary, see next chapter.
• Check, replace if necessary; see chapter after next.
Activity
D460_230V | D460F_230V
38
Publicité
