Publicité
14.4
Settings
Headstock
Tailstock
Spindle speed
Risk of injury from flying parts!
Always set the lowest spindle speed for unknown types of wood, for new
workpieces and for large workpieces!
Carefully increase the spindle speed!!
D460
The spindle speed is determined by the drive belt position of the 5-step pulley arrangement:
D460F
The machine has a 3-step pulley arrangement for positioning the drive belt.
HOLZMANN MASCHINEN GmbH
Spur center
• Push the spur center into the headstock receptacle
(1) with a jerk.
• To remove it, push the fixing rod into the rear end of
the headstock shaft (2). The spur center comes out
of the headstock receptacle.
Face plate
• Screw the face plate onto the thread of the
headstock shaft (3).
• To loosen the face plate, fix the headstock shaft (4)
with the fixing rod and at the same time unscrew
the face plate with the open end wrench (5).
Position
• Open the locking handle (6) and move the tailstock
along the machine bed, depending on the
workpiece size.
• Fix the locking handle (6) again.
Centre punch tip
• Push the centre punch tip into the tailstock
receptacle (7) with a jerk.
• To remove it, push the fixing rod into the end of the
tailstock shaft (8).
C A U T I O N
www.holzmann-maschinen.at
Spindle speed
A: 600 rpm
B: 910 rpm
C: 1340 rpm
D: 1960 rpm
E: 2800 rpm
ASSEMBLY
34
D460_230V | D460F_230V
Publicité
