Publicité
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Regardless of all safety regulations, your common sense and your appropriate technical
aptitude/training are and remain the most important safety factor in the error-free operation of
the machine. Safe working depends on you!
TRANSPORT
For proper transport, follow the instructions and information on the transport packaging
regarding center of gravity, slinging points, weight, means of transport to be used and prescribed
transport position, etc.
Transport the machine in its packaging to the place of installation. Ensure the correct body
posture when lifting, carrying and setting down the load.
Lifting/Setting down
- When lifting/setting down, ensure that you are standing firmly (legs hip-width).
- Lift/set down load with knees bent and back straight.
- Do not lift/set down load with a jerk.
Carrying
- Carry load with both hands as close to body as possible.
- Carry load with straight back.
- When transporting the assembled machine, ensure to lift it only by the machine body and
not by the attachments.
If you transport the machine with a vehicle, ensure that the load is secured appropriately!
ASSEMBLY
14.1
Preparation
Delivery content
Check the delivery immediately for transport damage and missing parts. Report any damage or
missing parts to your dealer or the shipping company immediately. Visible transport damage must
also be noted immediately on the delivery note in accordance with the provisions of the warranty,
otherwise the goods are deemed to have been properly accepted.
Requirements for the installation site
The chosen installation site must ensure a suitable connection to the electrical power supply and
have a connection to the extraction system. The installation site must meet the required safety
regulations and ergonomic operating conditions, such as lighting, space requirements and
working position. Place the machine on a level solid base with appropriate load-bearing capacity
for machine and workpiece. When dimensioning the required space, take into account that the
operation, maintenance and repair of the machine must be possible without restriction at all
times.
Preparation of the surface
Remove the preservative applied to protect the parts against corrosion without painting. This can
be done with the usual solvents. Do not use nitro solvents or similar agents and in no case water.
The use of paint thinners, petrol, aggressive chemicals or scouring agents will cause
damage to the surfaces!
Therefore: Use only mild cleaning agents for cleaning.
HOLZMANN MASCHINEN GmbH
N O T E
N O T E
www.holzmann-maschinen.at
TRANSPORT
32
D460_230V | D460F_230V
Publicité
