Publicité
ENGLISH
3. Open the steam/hot water knob (Fig.1-7) slowly by
turning it counter-clockwise.
4. Press the brew button (Fig.1-1) and the steam button
(Fig.1-3).
5. Dispense the whole water tank content through the
steam wand.
6. To stop dispensing, press the brew button (Fig.1-1)
and the steam button (Fig.1-3) again.
7. Close the knob (Fig.1-7) by turning it clockwise.
8. Fill the water tank with fresh drinking water (Fig.2).
9. Insert the filter holder into the brew unit from the
bottom (Fig.3) and turn it from left to right until it
locks into place (Fig.4).
10. Place a suitable container under the filter holder.
11. Press the brew button (Fig.1-1) and dispense all the
water in the tank.
12. Once the water tank is empty, stop dispensing by
pressing the brew button again (Fig.1-1) and empty
out the container.
13. Remove the filter holder from the unit by turning
it from right to left and rinse it with fresh drinking
water.
14. The machine is now ready for use.
BREWING AN ESPRESSO USING GROUND
COFFEE
The filter holder supplied features the "crema perfetta"
filter to prepare one or two coffees.
Warning! If the "crema perfetta" filter is used without
the frothing jet device, the machine will squirt out the
coffee, which may result in burns.
Note.
If you prefer to use the traditional filter (Fig.6/7),
remove both the "crema perfetta" filter (Fig.5) and the
frothing jet device (Fig.1-16).
To brew the first coffee, it is necessary to preheat the filter
holder first (Fig.1-17):
1. Insert the filter holder (Fig.1-17) into the brew unit
(Fig.1-8) with a 45° movement to the left and turn it
to the right to lock it in place. The filter holder handle
must be perpendicular to the machine or slightly
tilted towards the right.
2. Place a large cup under the filter holder (Fig.1-17) and
press the brew button (Fig.1-1)
3. After the cup of water has been filled (about 150cc),
press the brew button again and wait a few minutes
for the machine to reach the correct temperature with
the filter holder inserted.
Note.
Any residual water inside the filter holder must be
removed before filling the filter with ground coffee.
Continue preparing the espresso:
4. Remove the filter holder (Fig.1-17) and fill it with
ground coffee using the measuring scoop provided
with the machine (Fig.1-20).
Add one measuring scoop of coffee for each cup.
Note.
It is recommended to ask roasting companies for
finely ground coffee suitable for use in coffee machines or
to purchase it from large retailers.
5. Press the coffee using the dedicated tamper (Fig.1-21).
The coffee must be pressed evenly to obtain a well
levelled and flat surface.
6. Remove any coffee residues from the edge of the filter
holder (Fig.1-17).
7. Insert the filter holder (Fig.1-17) into the brew unit
(Fig.1-8) with a 45° movement to the left and turn it
to the right to lock it in place. The filter holder handle
must be perpendicular to the machine or slightly
tilted towards the right.
8. Wait until the indicator light turns on (Fig.1-5).
9. Press the brew button (Fig.1-1).
• 14 •
Publicité
