Publicité
INTRODUCTION
Before using your machine for the first time, please read
the safety manual provided separately very carefully and
store it for future reference.
FILTERS SUPPLIED
"Crema perfetta" filter for 1 or 2 cups (Fig.5).
This filter is already installed on the filter holder and allows
you to obtain an espresso with cream even when using the
machine for the first time.
Note.
This filter must be used only together with the
frothing jet device. (Fig.1-16).
Traditional filter for 2 cups (Fig.7).
Traditional filter for 1 cup / single-dose
pod (Fig.6).
These filters are like those used in professional bar ma-
chines and require manual skills and experience.
Note.
These filters must not be used with the frothing
jet device. (Fig.1-16).
Our advice is to start with the "crema perfetta" filter and
then, once you have acquired manual skills and experience,
move on to traditional ones to appreciate real barista use.
FIRST INSTALLATION
1. Remove the water tank cover (Fig.2) and fill it with
cold water up to the MAX level of the tank (Fig.1-13).
2. Insert the plug into the outlet at the back of the
machine (Fig.9) and the other end of the power cord
into a wall socket with suitable voltage.
Press the on / off button (Fig.1-2), the power indicator
light turns on(Fig.1-4).
Loading the circuit.
Warning! Do not activate the brew button without
loading the circuit first.
1. Place an empty cup under the brew unit (Fig.1-8)
without inserting the filter holder and press the brew
button (Fig.1-1).
You will hear the sound of the pump being activated
and after a few seconds the water will start to come
out of the brew unit (Fig.1-8).
2. After filling the cup (about 150cc), press the brew
button again (Fig.1-1).
Note.
The pump self-primer might not work temporarily
because of an "air bubble".
If water does not come out of the brew unit (Fig.1-8),
continue as follows:
1. Place a cup under the steam wand (Fig.1-14).
2. Turn the knob (Fig.1-7) counter-clockwise to open the
steam/hot water dispensing knob.
3. Press the brew button (Fig.1-1) to activate the pump.
4. After a few seconds, water will start coming out of
the steam wand.
Dispense about a cup of water.
5. Close the steam/hot water dispensing knob (Fig.1-7).
6. Press the brew button again (Fig.1-1).
Note.
After priming the circuit and when hot water is
dispensed from the steam wand, there might be some water
left inside. To drain it, we recommend dispensing some steam
for a few seconds.
When using for the first time or after a
period of inactivity of more than 2 weeks.
Note.
The water dispensed during this process must be
thrown away and is not suitable for food use. If the container
fills up during the cycle, stop dispensing water and empty the
container before resuming the operation.
1. Rinse the water tank (Fig.2) (see section "Cleaning
the Water Tank") and fill it with fresh drinking water.
2. Place a container under the steam wand (Fig.1-14).
• 13 •
ENGLISH
Publicité
