Alimak Tractel Rollclamp Manuel D'installation, D'emploi Et D'entretien page 17

24. To use the rollclamp device device if the securing
strap is damaged or if the unit shows any signs of
abnormal deformation or wear.
25. To secure yourself to the rollclamp device device by
any other means than the securing strap or at any
other location.
26. To use an anchor device if a rescue plan has
not been set up beforehand to cover a possible
operator fall.
27. To install an anchor device on a beam supporting
electrical cables, compressed air pipes, or other.
28. To use an anchor device for any use other than as
an anchor point for a PPE.
14. Equipment Compliance
TRACTEL SAS RD 619 – Saint-Hilaire-sous-Romilly
– F-10102 Romilly-sur-Seine France hereby declares
that the safety equipment described in this manual,
• complies with the requirements of European regulation
UE 2016/425 of March 2016.
• is identical to the PPE subject of the EU type
examination issued APAVE Exploitation France SAS –
6 rue du Général Audran 92412 COURBEVOIE cedex
– France, identified by the number 0082, and tested
according to standard EN 795 of 2012,
• is subject to the procedure referred to in Annex VIII
of the EU Regulation 2016/425 of the European
Parliament, Module D, under the control of a notified
body: APAVE Exploitation France SAS – 6 rue du
Général Audran 92412 COURBEVOIE cedex –
France, identified by the number 0082.
15. Marking
The marking on each product indicates:
a: the trade name: Tractel
b: the name of this equipment.
c: the referenced standard.
d: this equipment reference.
e: CE Logo followed
identification number of the approved body
responsible for production control.
f: Year and month of manufacture.
g: the serial number.
h: a pictogram showing that the manual must be read
before use.
o: The minimum breaking strength of the anchor
device
W: Maximum operating load.
p: maximum number of operators.
aa.: date of next periodic inspection.
16. Periodic inspection and repair
An annual periodic inspection is required, but depending
on the frequency of use, environmental conditions
.
®
by the number 0082,
and regulations of the company or the country of use,
periodic inspections may be more frequent.
Periodic inspections should be carried out by an
authorised and competent technician, in compliance
with the manufacturer's instructions transcribed in the
file "Tractel PPE inspection instructions".
®
Confirmation of the legibility of the product markings
should be an integral part of the periodic inspection.
On completion of the periodic inspection, the return to
service must be indicated in writing by the authorised
and competent technician who carried out the
inspection. This return to service must be recorded on
the inspection sheet in the middle of this manual. This
inspection record should be retained throughout the
product's life cycle, up until it is recycled.
After arresting a fall, this product must undergo a
periodic inspection as described in the current article.
The product's textile components must be changed,
even though they may not display any visible changes.
17. Lifespan
To ensure safe and effective use of this product, it is
mandatory to follow these guidelines below:
– Use the product strictly according to the instructions
provided in this manual.
– Have a competent person perform an ASI at least
every 12 months to confirm it is still safe to use, and
obtain written confirmation of its fitness for use.
– Store and transport the product in accordance with
the instructions in this manual.
Providing that these guidelines are strictly followed,
the product will have no end of service life date. If the
product includes textile components, these components
must be replaced after a maximum of 20 years from
their date of manufacture.
18. Withdrawal from service
When disposing of the product, all components must
be recycled by firstly sorting them into metallic and
synthetic materials. These materials must be recycled
by specialist bodies. During disposal, dismantling and
separating the components should be undertaken by a
duly trained person.
19. Manufacturer's name and address
Tractel SAS - RD 619 - BP 38
Saint Hilaire sous Romilly
10102 Romilly sur Seine
France
EN
17