Coating Materials Suitable For Use; Coating Materials Not Suitable For Use; Preparation Of The Coating Material; Start-Up - WAGNER WOOD & METAL SPRAYER W 200 Mode D'emploi

GB

5. Coating Materials Suitable for Use

Water- and solvent-based paints, finishes, primers, 2-component paints, clear finishes,
automotive finishes, staining sealers and wood sealer-preservatives.
All coating materials with the red Perfect Spray logo.

6. Coating Materials Not Suitable for Use

Wall paints without the red Perfect Spray logo.
Materials that contain highly abrasive components, plaster, facade paint, caustic solutions
and acidic coating substances. Flammable materials.

7. Preparation of the Coating Material

The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet
of the manufacturer ( Internet Download).
1. Stir the material up and put the required amount into the paint container.
Sprayed material
Glazes
Wood preservatives, mordants, oils, disinfection agents,
plant protective agents
Paints containing solvents and water-soluble paints,
primers, vehicle coating paints, thick-film glazes
Wall paints with the red Perfect Spray logo
2. If the convey capacity is too low, add 5 - 10 % dilution step-by-step until the convey
capacity fulfils your requirements.

8. Start-up

Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Attach the carrying strap to the unit. (Fig. 2)
•
Unscrew the container from the spray gun.
•
Aligning suction tube. (Fig. 3)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 3 A)
When spraying objects overhead, turn suction tube back. (Fig. 3 B)
20
Thinning recommendation
undiluted
undiluted
dilute by 5 - 10 %
dilute in accordance with
manufacturer's instructions
W 200