Hettich ROTANTA 460 R Mode D'emploi page 125

7.2 Programming
7.2.1 Write protection for programs
7.2.2 Opening or loading programs
7.2.3 Entering or changing programs
AB5650en
Write protection can be enabled or disabled when the rotor is at a standstill.
1. Open the desired program.
[PROG] button.
2. Press the
�� The RCL parameter is displayed.
3. Press and hold the
�� The STO parameter is displayed.
'Set Protection = 1-' is displayed after 8 seconds.
[Rotary knob] to set '+' or '-' .
4. Use
+ = The program is write-protected
- = The program is not write-protected
[START] button.
5. Press the
�� The setting is stored.
1. Press the [PROG] button.
�� The RCL parameter is displayed.
[Rotary knob] to set the desired program location.
2. Use the
[START] button.
3. Press the
'Program recall...' is displayed briefly.
��
The centrifugation data of the desired program location is dis-
played
The previous data in the program location is overwritten
upon saving.
If "Protected !!" is displayed, the data in the program loca-
tion is write-protected and saving is not possible.
1. Set the desired parameters.
[PROG] button repeatedly until the 'STO' parameter is dis-
2. Press the
played.
[Rotary knob] to set the desired program location.
3. Use the
If a "+" is displayed after the program location, the
data is write-protected.
The write protection must be removed before data
can be saved.
[START] button.
4. Press the
�� Settings are stored in the desired program location.
'Program store...' is displayed briefly.
Rev.: 24 / 01.2024
[PROG] button.
Software operation
47 / 73