Hettich ROTANTA 460 R Mode D'emploi page 111

4
Fig. 28: Rotor installation and
removal
1 Groove
2 Motor shaft
3 Driver
4 Hole
Installing the rotor with a
clamping nut
6.3 Inserting and removing buckets
Inserting buckets
AB5650en
1. Open the lid.
2. Loosen the rotor clamping nut using the supplied spanner.
�� After passing the working point for lifting the rotor, the rotor
detaches from the cone of the motor shaft (
1
3. Turn the clamping nut until the rotor can be lifted off the motor shaft.
4. Remove the rotor.
2
3
Personnel:
■
Trained user
The lid is open.
1. Clean the motor shaft (
2. Lightly grease the motor shaft (
cleaning and disinfection' on page 63 .
3. Place the rotor vertically on the motor shaft (
3 ) of the motor shaft must be in the groove ( 1 ) of the
The driver (
rotor. The orientation of the groove is marked on the rotor.
4. Hand-tighten the rotor clamping nut using the supplied spanner.
5. Check that the rotor is firmly seated.
NOTICE
Damage to the device due to imbalances caused by incor-
rect loading of the rotor.
−
Buckets marked with the number of the rotor location may
only be used there.
Buckets marked with a set number may only be used
together.
Rev.: 24 / 01.2024
2 ) and rotor hole ( 4 ).
2 ), see ⮫ Chapter 8.2 'Instructions for
Load all swing-out rotor locations with the same
buckets.
Operation
2 ).
2 ).
33 / 73