Efco GST 360 Manuel D'utilisation Et D'entretien page 27

TRANSLATION OF ORIGINAL INSTRUCTIONS
To our valued customers
Thank you for selecting an Emak product.
Our network of dealers and authorized
workshops will always be at your complete
disposal for any need you may have.
INTRODUCTION
For correct use of the machine and to avoid
accidents, do not start working until you have
read this manual carefully. You will find
explanations concerning the operation of the
various parts plus instructions for necessary
checks and relative maintenance.
NOTE: The descriptions and illustrations
contained in this manual are not binding. The
manufacturer reserves the right to undertake
any modifications it deems necessary without
revising this manual.
In addition to the operating instructions, this
manual contains paragraphs that require your
special attention. Such paragraphs are marked
with the symbols described below:
WARNING: where there is a risk of an accident or
personal, even fatal, injury or serious damage to
property.
CAUTION: where there is a risk of damaging the
machine or its individual components.
WARNING
RISK OF HEARING DAMAGE
IN NORMAL CONDITIONS OF USE, THIS MACHINE
MAY EXPOSE THE OPERATOR TO A PERSONAL DAILY
NOISE LEVEL EQUAL TO OR HIGHER THAN
85 dB (A)
CONTENTS
1. EXPLANATION OF SYMBOLS AND
SAFETY WARNINGS _______________ 23
2. CHAIN SAW COMPONENTS _________ 23
3. SAFETY PRECAUTION _____________ 24
4. FITTING THE BAR AND CHAIN _______ 25
5. STARTING _______________________ 26
6. STOPPING THE ENGINE ____________ 28
7. USE ____________________________ 28
8. MAINTENANCE ___________________ 31
9. STORAGE ________________________ 34
10. TECHNICAL DATA _________________ 35
11. DECLARATION OF CONFORMITY ____ 36
12. WARRANTY CERTIFICATE __________ 37
13. TROUBLE SHOOTING CHART _______ 38
1. EXPLANATION OF SYMBOLS AND
SAFETY WARNINGS (Fig.1)
1. Read operator's instruction book before
operating this machine.
2. Wear head, eye and ear protection.
3. Type of machine: CHAIN SAW.
4. Guaranteed sound power level
5. Serial number
6. CE conformity marking.
7. Warning! Kickback it's danger.
8. Read, understand and follow all warnings.
9. This saw is for trained tree service operators
only.
10. Use appropriate protections for foot-leg and
hand-arm.
11. Year of manufacture
12. Primer bulb
13. Chain brake, activated (right). Chain brake,
not activated (left).
14. WARNING! - The surface can be hot!
2. CHAIN SAW COMPONENTS (Fig. 2)
1. Choke lever
2. Throttle trigger
3. Throttle trigger lockout
4. Carburetor adjustment screws
5. Inertial brake lever
6. Exhaust muffler
7. Chain
8. Guide bar
9. Air filter cover
10. STOP button
11. Fuel tank cap
12. Starter handle
13. Oil tank cap
14. Primer bulb
15. Lateral chain tensioner screw
16. Front handle
17. Rear handle
18. Bar cover
I
GB
F
D
E
NL
P
GR
TR
CZ
SK
RUS
UK
PL
H
LV
EST
LT
RO
23