Parkside PMSG 200 A2 Consignes D'utilisation Et De Sécurité page 26

ATTENTION:
The arc radiation can lead to inflammation of the eyes and skin burns.
„
Casting and welding slag can cause eye injuries and burns.
„
Fit the welding mask as described below in the section "Fit welding mask".
„
It is essential that you only use the welding cable which is included with the delivery.
„
Choose between push and drag welding. The following section shows the impact of the direction of
movement on the properties of the weld seam:
Burn
Weld seam width
Weld bead
Weld seam fault
NOTE: You decide for yourself which type of welding is most suitable, once you have welded a
sample piece.
NOTE: Once it has worn down completely, the electrode must be replaced.
Welding mask
If you do not use the welding protection shield, harmful UV radiation and heat emitted by the arc could
damage your eyes. Always use the welding protection shield for welding work.
z TIG welding
For TIG welding please follow the instructions for your TIG torch. You can select TIG mode by pressing
the welding mode selector key
z Maintenance and cleaning
NOTE: The welding device must be regularly serviced and overhauled for proper function and
for compliance with the safety requirements. Improper and wrong operation may cause failures and
damage to the device. Repairs must only be carried out by qualified electricians.
Switch off the main power supply and the main switch of the device off prior to performing any
„
maintenance work on the welding device.
Clean the welding device and accessories regularly using air, cotton waste or a brush.
„
In case of a defect or a necessary replacement of equipment parts, please contact the appropriate
„
qualified personnel.
26
GB/IE/NI/CY/MT
Push welding
smaller
larger
flatter
larger
HEALTH HAZARD!
. To do this select the "TIG" position.
35
Drag welding
larger
smaller
higher
smaller