Parkside PMSG 200 A2 Consignes D'utilisation Et De Sécurité page 18

Feed roll, welding nozzle and wire cross-section must be compatible with one another.
The device is suitable for wire reels weighing up to maximum 5000 g.
Use aluminium wire to weld aluminium and steel wire to weld steel and iron.
z Adaptation of device to solid welding wire with inert gas
The correct connections for solid wire welding when using inert gas are shown in Fig. S. When using the
aluminium solid wire delivered with the product, then you must use argon as the inert gas (not included
with the delivery).
S
38
32
10
First connect the plug
„
in a clockwise direction. If you are in any doubt, then please contact a professional.
Now connect the cable assembly with direct connection
„
Fix the connection in place by tightening the fixing ring
Then connect the earth cable
„
To fix the connection in place, rotate in a clockwise direction.
T
Pull the protective cap off the gas connection
„
Now connect the inert gas feed including the pressure reducer (not included with the delivery) to the
„
gas connection
33
18
GB/IE/NI/CY/MT
with the connector marked with the "+" (see Fig. S). To fix it in place, rotate
32
with the corresponding connector, marked with the "-" (see Fig. S).
4
(see Fig. T). Inert gas is required if you are not using flux-cored wire with
4
to the appropriate connector (see Fig. S).
10
in a clockwise direction.
38
5
33
.
33