Parkside PMSG 200 A2 Consignes D'utilisation Et De Sécurité page 7

z Intended use
The device is designed for MIG welding (welding with welding wire and inert gas), MMA welding
(welding with rod electrodes) and TIG welding (tungsten inert gas welding). When using solid wires
which do not contain inert gas in solid form, then you must use inert gas in addition. When using
aluminium solid wire, then you must use argon as the inert gas. When using self-shielding flux-cored
wire, you do not need to use any additional gas. In this case, the inert gas is contained in the welding
wire in powdered form and is therefore channelled straight into the arc. This means that the device
is not susceptible to wind when working outdoors. Only suitable wire electrodes may be used for the
device. This welding device is designed for manual arc welding (MMA welding) of steel, stainless steel,
steel sheet and cast materials, using the appropriate coated electrodes. Refer to the information from
the electrode manufacturer. Only suitable electrodes may be used for the device. For tungsten inert gas
welding (TIG welding) it is essential that you observe the operating and safety instructions for the TIG
torch you are using, in addition to the instructions and safety instructions in these operating instructions.
If it is not handled properly the product can be dangerous for individuals, animals and property.
The welding mask must only be used with protective welding glasses as well as prescription glasses
which are marked appropriately, used properly and as a general rule, are only used for welding.
The welding mask is not designed for laser welding! Use the product only as described and only for
the specific applications as stated. Keep these instructions in a safe place. Ensure you hand over all
documentation when passing the product on to anyone else. Any use that differs to the intended use as
stated above is prohibited and potentially dangerous. Damage or injury caused by misuse or disregarding
the above warning is not covered by the warranty or any liability on the part of the manufacturer.
Commercial use will void the guarantee. Observing the safety instructions and assembly instructions and
operating information in the instructions for use is also a component of the intended use. It is imperative
to adhere to the applicable accident prevention regulations. The device must not be used:
in insufficiently ventilated rooms,
„
in explosive environments,
„
to defrost pipes,
„
in the vicinity of people with cardiac pacemakers and
„
in close proximity to easily flammable materials.
„
Residual risk
Even if you operate the device as intended, there will be residual risks. The following dangers may occur
in connection with the build and design of this multi-process welder:
Eye injuries caused by glare, touching hot parts of the device or workpiece (burn injury),
„
In case of improper protection, risk of accident and fire through sparks and slag particles,
„
Harmful emissions from smoke and gases if there is a lack of air or if closed rooms are insufficiently
„
extracted.
NOTE: Reduce the residual risk by carefully using the device as intended and observing all
instructions.
z Package contents
1 Multi-Process Welder PMSG 200 A2
1 1.0 mm welding nozzle (pre-fitted, only for solid aluminium wire) labelling: 1.0 A
4 welding nozzles for steel/flux-cored wire (1x 0.6 mm; 1x 0.8 mm; 1x 0.9 mm; 1x 1.0 mm)
Labelling in accordance with the diameter: 0.6; 0.8; 0.9; 1.0
1 chipping hammer with wire brush
1 solid aluminium wire 200 g (pre-fitted, 1.0 mm Ø, type: ER5356
GB/IE/NI/CY/MT
7