Parkside PMSG 200 A2 Consignes D'utilisation Et De Sécurité page 24

Overlap welds
The most common preparation is that with the straight weld edges. The weld can be released using a
standard angle weld seam. Both workpieces must be brought as close to each other as possible, as
shown in Fig. AB.
AB
z MMA welding
Make sure that the main switch
„
plugged into the socket.
Connect the electrode holder
„
Also refer to the information from the electrode manufacturer.
Put on appropriate protective clothing in accordance with the specifications and prepare your
„
workspace.
Connect the earth terminal
„
Clamp the electrode into the electrode holder
„
Switch the device on by setting the main switch to the
„
Select "MMA" mode by pressing the selector switch for welding mode
„
lamp "MMA" lights up.
Adjust the welding current using the rotary switch for welding current adjustment
„
the electrode you are using.
AC
24
GB/IE/NI/CY/MT
is set to position "O" ("OFF") or that the power plug
5
and the earth terminal
34
to the workpiece.
4
34
6
34
4
to the welding device, as shown in Fig. AC).
4
.
"I" ("ON") position.
5
is not
3
, until the small indicator
35
depending on
6