Parkside PMSG 200 A2 Consignes D'utilisation Et De Sécurité page 13

for the welding current from the electrode to the earth terminal.
Never connect the earth terminal to the housing of the welder!
Never connect the earth terminal to earthed parts far away from
the workpiece, e.g. a water pipe in another corner of the room.
This could otherwise damage the protective bonding system of the
room you are welding.
Do not use the welder in the rain.
„
Do not use the welder in a moist environment.
„
Only place the welder on a level surface.
„
The output is rated at an ambient temperature of 20 °C.
„
The welding time may be reduced in higher temperatures.
RISK OF ELECTRIC SHOCK:
Electric shock from a welding electrode can be fatal. Do not weld
„
in rain or snow. Wear dry insulating gloves. Do not touch the
electrodes with bare hands. Do not wear wet or damaged gloves.
Protect yourself from electric shock with insulation against the
workpiece. Do not open the device housing.
DANGER FROM WELDING FUMES:
Inhalation of welding fumes can endanger health. Do not keep
„
your head in the fumes. Use the equipment in open areas.
Use extractors to remove the fumes.
DANGER FROM WELDING SPARKS:
Welding sparks can cause an explosion or fire. Keep flammable
„
substances away from the welding location. Do not weld near
flammable materials. Welding sparks can cause fires. Keep a fire
extinguisher close by and an observer should be present to be
able to use it immediately. Do not weld on drums or any other
closed containers.
DANGER FROM ARC BEAMS:
Arc beams can damage your eyes and injure your skin. Wear a
„
hat and safety goggles. Wear hearing protection and high, closed
shirt collars. Wear welding safety helmets and make sure you use
the appropriate filter settings. Wear complete body protection.
DANGER FROM ELECTROMAGNETIC FIELDS:
Welding current generates electromagnetic fields. Do not use if you
„
have a medical implant. Never wrap the welding cable around
your body. Guide welding cables together.
z Welding mask-specific safety instructions
With the help of a bright light source (e.g. lighter) always check
„
the proper functioning of the welding mask prior to starting with
GB/IE/NI/CY/MT
13