Publicité
Les langues disponibles
Les langues disponibles
integrated solid inert gas. If necessary, observe the notes for your pressure reducer (not included
with the delivery). You can use the following formula as a guideline for adjusting the gas flow:
Wire diameter in mm x 10 = gas flow in l/min
For example, using 0.8 mm wire, will give a value of approx. 8 l/min.
z Adaptation of device to flux-cored welding wire without inert gas
If you are using flux-cored welding wire with integrated inert gas, then you do not have to have an
external inert gas supply.
First connect the plug
„
clockwise direction. If you are in any doubt, then please contact a professional. Connect the cable
assembly with direct connection
fixing ring
in a clockwise direction.
38
Then connect the earth cable
„
the connection in place, rotate in a clockwise direction.
z Inserting welding wire
Unlock and open the cover of the wire feed unit
„
Unlock the roller unit by turning the roller mount
„
Pull the roller mount
„
NOTE: Make sure that the end of the wire does not come loose and cause the roll to roll out on its
own. The end of the wire may not be released until during assembly.
Completely unpack the welding wire reel
„
Do not release the wire end yet.
Place the wire reel on the shaft. Make sure that the roll unwinds on the side of the
„
(see Fig. G and M).
Place the roll mount
„
Undo the adjustment screw
„
Turn the thrust roller unit
„
Loosen the feed roll holder
„
On the top of the feed roll
„
If necessary, the feed roll
wire (Ø 1.0 mm) must be used in the feed roll
The welding wire must be positioned in the upper groove!
Erect the feed roll holder
„
Remove the torch nozzle
„
Unscrew the welding
„
Guide the cable assembly with direct connection
„
possible (place it on the floor).
Take the wire end out of the edge of the spool (see Fig. L).
„
Trim the wire end with wire scissors or a diagonal cutter in order to remove the damaged, bent ends
„
of the wire (see Fig. L).
NOTE: The welding wire must be kept under tension the entire time in order to avoid a releasing
and a roll out! Therefore it is recommended to carry out the work with an additional person.
Push the welding wire through the wire feed guide
„
Guide the welding wire along the feed roll
„
Swivel the thrust roller unit
„
with the connector marked with the "-". To fix it in place, rotate in a
32
to the appropriate connector. To fix the connection, tighten the
10
with the corresponding connector, marked with the "+" and to fix
4
off the shaft (see Fig. F).
27
15
back on and lock it by pressing and turning it clockwise (see Fig. G).
27
and swing it downwards (see Fig. H).
25
to the side (see Fig. I).
26
by turning it anti-clockwise and pull it forwards and off (see Fig. J).
28
, check whether the appropriate wire thickness is indicated.
18
has to be turned over or replaced (see Fig. N). The supplied welding
18
again and screw clockwise direction.
28
by pulling and turning it clockwise (see Fig. K).
7
nozzle (see Fig. K).
14
18
towards the feed roll
26
, by pushing the release knob upwards.
1
anti-clockwise (see Fig. F).
27
, so that it can unrolled without difficulty.
with the specified wire thickness of Ø 1.0 mm.
18
away from the welding device as straight as
10
(see Fig. M).
29
and push it into the cable assembly holder
(see Fig. O).
18
wire feed guide
29
30
GB/IE/NI/CY/MT
(see Fig. N).
19
Publicité
