Siemens SICHARGE D 8EM5907-0AA01-1AA4 Information Du Produit page 95

4. Remove the four M6x12 cylinder head screw and pull the rope out of the pulley cross.
5. Place the pulley cross on the jib and screw the pulley cross to the jib.
Tighten the screws to 5 Nm.
Figure 26 Assembly and disassembly of the pulley crosses
①
6. Pull the rope out over the horizontal guide
Figure 27 Laying the rope
Installation of the cable management system V1.6
A5E53160522-AC, 05/2024
②
and between the two vertical guides
Repair
③
of the pulley cross.
95