Publicité
Les langues disponibles
Les langues disponibles
Installing the cable management
Installing the mounting plates
The following operating instruction shows how to install the mounting plates of the cable management of the charging station.
If you install the cable management system afterwards, make sure that the system is completely isolated from the power supply.
WARNING
Do not pull on the rope of the rope box
Do not pull on the rope of the rope box because the spring force can cause injuries or damage to the cable management due
to the rope-stopping mechanism.
1.
Screw in one nipple each
left. The tightening torque is 3 Nm.
Figure 2
Example: Bezel bracket, right
2.
Place the two square washers with the two holes
Place the two small square washers
Figure 3
Fitting the shim plates
82
②
with an M4 hexagon nut
①
②
on the M12 threads on the front of the charging station.
①
to the bezel bracket on the right
on the M12 threads on the back.
Installation of the cable management system V1.6
③
and the bezel bracket on the
A5E53160522-AC, 05/2024
Publicité
