Siemens SICHARGE D 8EM5907-0AA01-1AA4 Information Du Produit page 81

Removing the roof
If you are assembling the cable management system during a new installation, skip these instructions and start here: Installing
the cable management (Page 82)
If you are retrofitting the cable management system on a SICHARGE D charging station, then proceed as follows to remove the
roof:
Figure 1 Removing the roof and filter bezel
1. Unlock the rear device door. With V1.5, lift out the device door. With V1.6, a hinge is installed.
2. First, pull out the filter bezel on the bottom. Then pull the filter bezel downwards.
3. Loosen the four quarter-turn fasteners and remove the filter box.
4. Loosen the M6 combi screws left and right for the roof.
5. Pull the roof off backwards and lift it down.
Note
Hand over the roof to the owner
Hand over the dismantled roof to the owner of the charging station.
Installation of the cable management system V1.6
A5E53160522-AC, 05/2024
81