Siemens SICHARGE D 8EM5907-0AA01-1AA4 Information Du Produit page 85

7. Tighten the bolts and nuts according to these instructions:
–
M12x30 hexagon screw: Wrench width 19 mm, the tightening torque is 46 Nm.
When tightening, make sure that the bezel brackets do not twist.
–
M6 hexagon nut/hexagon screw: Wrench width 10 mm, the tightening torque is 8 Nm
–
M8 hexagon nut: Wrench width 13 mm, the tightening torque is 13 Nm
If you operate the charging station in accordance with German calibration law, then seal the cover plate with sealing
①
stickers .
Figure 8 Sealing sticker
Installation of the cable management system V1.6
A5E53160522-AC, 05/2024
①
on the cover plate
Installing the cable management
85