Siemens SICHARGE D 8EM5907-0AA01-1AA4 Information Du Produit page 83

3. Place the two mounting plates for the left and right DC charging points on the charging station.
Figure 4 Placing the mounting plates
4.
Note
Cover the fan cutout, using a piece of cardboard, for example. Covering it prevents screws, for example, from falling in and
causing damage during operation.
Place the panel holder on the left and the panel holder on the right parallel to the
cutout.
Screw the mounting plates to the two washers on the back of the charging station
with the M6 screws.
Screw the mounting plates together with the four M12x30 hexagon screws. Make
sure that the bezel brackets do not twist when screwing in. Do not tighten the
screws yet.
Figure 5 Screwing the mounting plates
Installation of the cable management system V1.6
A5E53160522-AC, 05/2024
Installing the cable management
83