Siemens SICHARGE D 8EM5907-0AA01-1AA4 Information Du Produit page 89

Removing the rope stopping mechanism
The following operating instruction shows how to remove the rope- stopping mechanism of the right charging point of the
charging station. The procedure for the left charging point is identical.
Figure 15 Removing the rope-stopping mechanism
NOTICE
Danger of crushing by rope box
The rope is tensioned by a spring tension mechanism in the rope box. Avoid crushing and burning. Pull the cable down on the
cable clamp until the rope clamp is relieved. This allows you to remove the rope clamp on the rope box.
Pull the cable at the cable clamp only until the rope clamp is relieved and free. If you pull too far, the rope clamp may damage
the pulleys in the pulley cross. Remove the rope-stopping mechanism with an 8 mm socket. Remove the pulley.
The figure below shows how to reduce load on the rope clamp, e.g. using a cable tie. This means that one person can carry out
this assembly step alone.
Figure 16 Reducing load on the rope clamp
Installation of the cable management system V1.6
A5E53160522-AC, 05/2024
Installing the cable management
89