Publicité
Les langues disponibles
Les langues disponibles
9.
Place the cover plate on the jib. Screw the cover plate to the jib with four M6x16 half-round head screws. The tightening torque
is 6 Nm.
Figure 23
Installing the cover plate
10. Mount the cable clamp as described in this section: Installing the cable clamp (Page 86)
11. Remove the rope stopping mechanism as described here: Removing the rope stopping mechanism (Page 89)
12. Mount the cover as described in this section: Installing the cover (Page 90)
Replacing the cable clamp
When replacing a cable clamp, follow these steps:
1.
To remove the cover, proceed in the reverse order to the installation. The installation is described here: Installing the cover
(Page 90)
2.
Secure the rope of the rope box. To do this, use the rope clamp and pulley. Install the rope stopping mechanism in reverse order
to the removal of the rope stopping mechanism. The procedure is described here: Removing the rope stopping mechanism
(Page 89)
3.
Remove the defective cable clamp.
4.
Install the new cable clamp. The installation is described here: Installing the cable clamp (Page 86)
5.
Remove the rope stopping mechanism. The procedure is described here: Removing the rope stopping mechanism (Page 89)
6.
Install the cover. The installation is described here: Installing the cover (Page 90)
Installation of the cable management system V1.6
A5E53160522-AC, 05/2024
Repair
93
Publicité
