Implements - Grillo 2500 Manuel D'utilisation

Translation of the original instructions

IMPLEMENTS

CAUTION: Before fitting the tines assembly, ratchet hubs or wheel extensions to the tiller shaft, check
that the shaft and the inside of the accessory to be mounted are perfectly clean. After having fitted the
accessory to the shaft, tighten the fixing screws thoroughly.
PLOUGHS
There are two kinds of ploughs available: single furrow plough and 180° roll-over plough. The latter is
especially suitable when working forwards and backwards, such as along rows of vines or fruit-trees.
The depth of the furrow may vary from 10 to 15 cm depending on the soil. The plough must be fitted
behind the tiller on the adjustable implement-holder (fig. 12). Remove the drag stake support, the split
pin and the pin, then fit the implement-holder. It is also necessary to remove the two tines assembly. Fit
the wheel extensions with the screws and then the rubber wheels type 5.00×10. In order to increase the
wheel adherence it is recommended to fit weighs on the wheels (fig. 11).
ADJUSTABLE FURROWER
The adjustable furrower is an implement especially designed and manufactured for tracing furrows for
sowing or irrigation (fig. 13). The possibility of adjusting the position of the two wings enables furrow
width to be regulated from minimum of 10 to maximum of 30 cm. Furrow depth can vary from 10 to 20
cm. When working particularly hard ground, it is recommended to till before using the furrower. It is very
easy to mount; just remove the drag stake and fit the furrower (fig. 15). It may be used in combination
with the tiller or fitting the rubber wheels.
WHEEL EXTENSIONS
The wheel extensions are fitted onto the tiller axle and they are necessary to fit the rubber wheels (fig.
11). They have no differential function.
SIDE TRANSFER WHEELS
These wheel make it easier to move the machine. They are mounted directly on the tiller side discs.
They do not act as differential and cannot be used together with the plough or the furrower.
FRONT TRANSFER WHEEL
The front wheel too is used to move the machine easily. This wheel can be adjusted in two different
positions: a transfer position and a working position, which are adjustable without other tools (fig. 8).
13