End Of Season Maintenance; Maintenance Summary Table; Implements - Grillo G46 Manuel D'utilisation

END OF SEASON MAINTENANCE

Clean the machine carefully, drain and replace the engine oil, the gearbox oil and the tiller oil.
Grease the PTO and clean the air filter. Sharpen and grease the tines, replacing them if worn.
PROCEDURE
check the level
Engine oil
Air filter
check/adjust
Spark plug
Check the level
Gearbox oil
Check that the engine intake grid is
clean
Check that tines are well-sharpened
and secured well
Lubricate with grease
● recommended procedure
‫ ٭‬procedure to be carried out if necessary
CONTRA-ROTATING TILLER
The rotary tiller is used to break the surface layer of the ground in order to increase its permeability
and at the same time to get rid of weeds. This tiller is ideal for hard soil where a traditional walking
tractor would be ineffective. Tiller and wheels move in the opposite direction to each other, allowing
the walking tractor to perfectly adhere to the ground and till the soil more powerfully. Allow the
walking tractor to move forwards under its own power to obtain optimum results. Tilling depth can
be adjusted by raising or lowering the central rear skid (fig. 9). On very demanding soil, this skid
can be removed altogether to increase the tilling depth. It is recommended to till very hard soil a
couple of times, raising the central rear skid little by little to allow the tiller to dig deeply into the
ground. Soft soil can be tilled to the required depth from the beginning. If the walking tractor does
not move forward properly, lower the rear skid to allow the machine to "flow" and steer the machine
without pushing on the handlebar.
Translation of the original instructions

MAINTENANCE SUMMARY TABLE

EVERY 8
HOURS
●
change
check ●
replace
replace
replace
●

IMPLEMENTS

AFTER EVERY
20 50
HOURS HOURS
●
● ●
● ●
●
11
EVERY EVERY
100 200
HOURS HOURS
●
‫٭‬
●
●
●