Scheppach BC-MP320-X Traduction Du Mode D'emploi Original page 25

9 Pre-commissioning
NOTE
Some noise pollution from this product is un-
avoidable. Postpone noisy work to approved
and designated times. If necessary, adhere to
rest periods and limit the duration of work to
the bare minimum.
For your personal protection and the protec-
tion of nearby persons, wear suitable hearing
protection.
9.1 Setting the cutting height
ATTENTION
The cutting height may only be adjusted
when the engine is shut off.
WARNING
Danger of injury!
To switch off the product, switch off the motor, wait for it
to stop, remove the battery and pull out the safety key.
• In dense, tall grass, set the highest cutting level and
mow more slowly. A high cutting height should be se-
lected for the first cut of the season. Adjust the cutting
height so that the product is not overloaded.
• Set the cutting height depending on the actual length
of the lawn.
• Carry out several passes so that a maximum of 4 cm
of lawn is removed at a time.
The cutting height is adjusted via the front and rear axles.
WARNING
Danger of crushing!
Pay attention to your fingers!
3 different cutting heights can be set:
1 =
2 =
3 =
1. Lay the lawnmower on its side.
2. Start by gripping the sides of the rear wheel axle with
both hands.
3. Then pull evenly on the wheel axle and allow it to
latch into the desired position.
4. Repeat the process on the front wheel axle.
Note:
Set the wheel axles to the same cutting height.
20 mm
45 mm
60 mm
www.scheppach.com
9.2 Inserting/removing the battery (12)
in the battery mount (Fig. 1, 7)
Inserting the battery
1. Open the cover (6).
2. Push the battery (12) into the battery mount (13). The
battery (12) clicks into place audibly.
3. Close the cover (6).
Removing the battery
1. Open the cover (6).
2. Press the unlock button (14) of the battery (12) and
remove it from the battery mount (13).
3. Close the cover (6).
9.3 Preparing the area to be mowed
1. Before mowing, carefully examine the area.
2. Remove stones, sticks, bones, wires, toys and other
objects that may be ejected by the product.
3. Ensure that no other people are present on the sur-
face to be mowed.
10 Operation
The battery-powered lawnmower has a cutting tool that
rotates parallel to the cutting plane. It is equipped with a
powerful and quiet-running electric motor, a robust hous-
ing, a safety bar, a safety key, a double-sided lawn edge
intake and a grass collection bag. The product also has
smooth-running wheels. Please refer to the following de-
scriptions for the function of the controls.
WARNING
Danger of injury!
Remove the battery from the power tool before carrying
out any work on the power tool (e.g. maintenance, tool
change, etc.) and when transporting and storing it.
There is a risk of injury if the on/off switch is operated
unintentionally.
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batteries
may only be charged with battery chargers of this se-
ries. Observe the manufacturer's instructions.
10.1 Mowing with the grass collection
basket
ATTENTION
Do not operate the product without the grass collection
basket fully attached.
ATTENTION
Only remove or attach the grass collection basket when
the engine is switched off and the blade is stationary.
GB | 25