gomag GO-KS200 Traduction Du Mode D'emploi Original page 43

9. Recheck the seating of the saw chain (5) and ten-
sion the saw chain (5) as described under Tension-
ing the saw chain (7) (Fig. 1).
Note:
With a new saw chain, the tensioning force decreases
after some time. Therefore, you must retension the saw
chain after the first 5 cuts, or after 10 minutes of sawing
at the latest.
12.5 Sharpening the saw chain (5)
WARNING
Increased risk of accidents due to an incor-
rectly sharpened saw chain!
Deviations from the dimensions of the cutting edge
geometry during sharpening increase the risk of kick-
back of the product.
– Have the saw chain sharpened by a professional.
The saw chain can be resharpened at an authorised
specialist workshop. Do not attempt to sharpen the saw
chain yourself if you do not have a suitable tool and the
necessary experience.
CAUTION
Special tools are required to sharpen the chain; these
ensure that the cutting tools are sharpened at the cor-
rect angle and to the correct depth.
All cutting links must have the same width and length
after sharpening.
Notes:
A sharp saw chain ensures optimum cutting perfor-
mance. It effortlessly eats through the wood, leaving
behind large, long wood chips.
A saw chain is blunt if you have to push the cutting
equipment through the wood and the wood chips are
very small. With a very blunt saw chain, no chips are
produced at all, only wood dust.
12.5.1 Instructions for sharpening the
chainsaw
File di- Top an-
ameter gle
Clamp-
ing ro-
Saw
tation
chain
angle
type
Bottom Top tilt Stan-
angle angle dard
(55°) depth
gauge
Clamp- Side
ing tilt angle
angle
www.scheppach.com
21PBX ap- 30°
prox.
4.8
mm
Depth stop
13 Storage and transport
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature is between 5°C and
30˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the product.
13.1 Preparation for storage
1. Attach the chain guide.
2. For transport or when storing the product, cover the
blade with the blade guard.
3. Remove the battery.
4. Empty the product completely.
5. Clean and check the product for damage.
13.2 Transport
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
• The product may only be transported on the handle
provided for this purpose.
14 Repair & ordering spare parts
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
10° 85° 0.64
mm
File
GB | 43