gomag GO-KS200 Traduction Du Mode D'emploi Original page 37

2. To prevent oil from leaking, use a funnel*.
3. Carefully add the chain lubricating oil until it reaches
the top mark on the oil level indicator (11). Oil tank
capacity: max. ml.
4. Screw down the cover of the oil tank (12) clockwise
to close the oil tank (12).
5. Wipe up any spilled oil carefully immediately and
dispose of the cloth according to local regulations.
6. To check the product lubrication, hold the chainsaw
with the saw chain over a sheet of paper and give it
full throttle for a few seconds. You can see on the
paper whether the chain lubrication is working.
* = not included in the scope of delivery!
8.4 Inserting/removing the battery
(18) into/from the battery mount
(10) (Fig. 4)
CAUTION
Danger of injury!
Do not insert the battery until the battery-powered
tool is ready for use.
Inserting the battery
1. Push the battery (18) into the battery mount (10).
The battery (18) clicks into place audibly.
Removing the battery
1. Press the unlocking button (19) of the battery (18)
and remove the battery (18) from the battery mount
(10).
8.5 Safety devices (Fig. 1)
• Rear handle (1) with hand guard
– Protects the hands from branches and twigs and
if the chain jumps off.
• On/off switch (2) with chain instant stop
– Switches the product off immediately if the on/
off switch is released.
• Chain brake/front hand guard (4)
– Safety devices that stop the saw chain immedi-
ately in the event of kick-back.
– The lever can also be manually actuated.
– Protects the left operator's left hand if it slips off
the front handle.
• Saw chain (5) with low kick-back
– Helps you to intercept kick-backs with specially
developed safety devices.
• Switch lock (9)
– To switch on the product, the switch lock must
be unlocked.
• Claw stop (13)
– Reinforces stability when vertical cuts are per-
formed and makes sawing easier.
9 Operation
The cordless chain saw is equipped with a quick-ten-
sioning system for the chain. The saw chain runs
around the edge of the guide bar (guide rail). An auto-
matic oil system ensures continuous chain lubrication.
To protect the users, the product has various safety de-
vices (see8.5).
Please refer to the following descriptions for the func-
tion of the controls.
ATTENTION
Always make sure the product is fully assembled
before commissioning!
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
DANGER
Danger of injury!
If the product is jammed, do not try to pull the product
out by using force.
– Switch off the engine.
– Use a lever arm or wedge to get the product free.
9.1 Chain brake (Fig. 1, 5)
WARNING
The chain brake must be checked before
each use.
The chain brake brakes the saw chain immediately in
the event of kick-back.
WARNING
Product damage!
Increased engine speed for too long with the chain
brake locked will damage the engine and the chain
drive.
If the saw chain still moves, contact the customer ser-
vice.
www.scheppach.com GB | 37