gomag GO-KS200 Traduction Du Mode D'emploi Original page 34

WARNING
This power tool generates an electromagnetic field
during operation. This field can impair active or pas-
sive medical implants under certain circumstances. In
order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the power tool.
WARNING
In case of extended working periods, the operating
personnel may suffer circulatory disturbances in their
hands (vibration white finger) due to vibrations.
Raynaud's syndrome is a vascular disease that caus-
es the small blood vessels on the fingers and toes to
cramp in spasms. The affected areas are no longer
supplied with sufficient blood and therefore appear
extremely pale. The frequent use of vibrating prod-
ucts can cause nerve damage in people whose circu-
lation is impaired (e.g. smokers, diabetics).
If you notice unusual adverse effects, stop working
immediately and seek medical advice.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
WARNING
Follow the safety instructions and the
notes regarding charging and correct use,
as specified in the operating manual for
your 20V gomag series battery and battery
charger. A detailed description of the
charging process and further information
are provided in this separate manual.
6 Technical data
Cordless chainsaw
Engine voltage
Motor speed
Motor current
Idle current
Protection class
Max. chain speed
Guide rail
Usable cutting length
Chain pitch
34 | GB
Driving link thickness
Number of chain wheel teeth 6 teeth / 9.525 mm (0.375")
Type of saw chain
(pre-fitted)
Type of guide rail
(premounted)
Tank / chain oil
Weight without guide bar
and chain
(without battery)
Weight with guide bar and
chain (without battery)
Subject to technical changes!
Noise and vibration
The noise and vibration values have been determined
in accordance with EN 62841-1.
Noise data
Sound pressure L
Measurement uncertainty K
Sound power L
Measurement uncertainty K
Vibration parameters
Vibration a
Front handle
Rear handle
Measurement uncertainty K
The total vibration emission values specified and the
device emissions values specified have been measured
in accordance with a standardised test procedure and
can be used for comparison of one electric tool with an-
other.
The total noise emission values specified and the total
GO-KS200
vibration emission values specified can also be used for
an initial estimation of the load.
20 V
rpm
23500
30 A
6 A
IPX0
6 m/s
254 mm (10")
20.0 cm
9.525 mm (0.375")
www.scheppach.com
WARNING
Noise can have serious effects on your health. If the
machine noise exceeds 85 dB, please wear suitable
hearing protection for you and persons in the vicinity.
pA
wA
h
1.09 mm (0.043")
Kangxin
3/8.043-40
Kangxin
AP10-40-437P
125 ml
2.6 kg
3.1 kg
79.3 dB
3 dB
pA
96.1 dB
3 dB
wA
1.46 m/s
2.27 m/s
1.5 m/s
2
2
2