Xenios Holder for Backup Pump Drive Mode D'emploi page 11

When adjusting the correct position of the Holder for
Backup Pump Drive (movable element with backup pump
drive), make sure that hand or fingers will not be pinched .
Ensure that the Holder for Backup Pump Drive and the
individual components are mounted and fixed securely
and screws are tightened . All screws shall be tightened and
loosened by hand only .
CAUTION
Do not expose the Holder for Backup Pump Drive to high
mechanical stress .
Do not use the Holder for Backup Pump Drive if it is
damaged (e .g . damages on screws, and holder frame) .
If the Holder for Backup Pump Drive is dropped or falls
down, the Holder for Backup Pump Drive and all fastening
components must be checked for damage . The damaged
holder or components should not be used further and
must be exchanged .
Note: The Holder for Backup Pump Drive may only be used to mount
the backup pump drive while backup pump drive is not active .
In addition to following the Instructions for Use, users must observe the
rules and regulations regarding occupational safety, accident prevention,
and environmental protection .
2. DEVICE DESCRIPTION
The Holder for Backup Pump Drive is a holder for the mounting and posi-
tioning of a console backup pump drive .
Item
Holder for Backup
Pump Drive
For SVHC information according to Article 33 of Regulation (EC)
No .1907/2006 ("REACH") please visit this page: www .xenios-ag .com/SVHC .
Weight
number
approx . 680 g 38350411
D E V I C E D E S C R I P T I O N
Item Max load
5 kg
EN
Material
Aluminum
11