Candy CA6 N5G3YTB Mode D'emploi page 7

atmospheric agents.
• This appliance is designed to be used at altitude lower than 2000m.
• To remove protective films and advertisement stickers on front
surface of the oven before first usage
ELECTRICAL WARNINGS
• The socket must be suitable for the load indicated on the tag and
must have ground contact connected and in operation. The earth
conductor is yellow-green in colour. This operation should be carried
out by a suitably qualified professional.
• Connection to the power source can be made by plug or by fixed
wiring placing an omnipolar breaker, with contact separation
compliant to the requirements for overvoltage category III, between
the appliance and the power source that can bear the maximum
connected load and that is in line with current legislation.
• ln case of incompatibility between the socket and the appliance
plug, ask a qualified electrician to substitute the socket with another
suitable type. The plug and the socket must be conformed to the
current norms of the installation country.
• The yellow-green earth cable should not be interrupted by the
breaker. The socket or omnipolar breaker used for the connection
should be easily accessible when the appliance is installed.
• lf the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a
hazard. For any repairs, refer only to the Customer Care Department
and request the use of original spare parts.
• Disconnect the appliance from the mains electricity supply before
carrying out any work or maintenance on it.
WARNING:
•
replacing the bulb, to avoid the possibility of electric shocks.
• The oven must be switched off before removing the removable parts.
After cleaning, reassemble them according the instructions.
• The use of any electrical appliance implies the observance of some
fundamental rules:
- do not pull on the power cable to disconnect the appliance from
the power source;
ensure that the appliance is switched off before
EN 7