Cub Cadet Pro Z Serie Manuel De L'utilisateur page 13

R
S
T †
F †
G
†
Y †
J
Z1 † †
NOTE: This Operator's Manual covers several models. Mower features may vary by
model. Not all features in this manual are applicable to all mower models and the
mower depicted may differ from yours.
NOTE: All references in this manual to the left or right side and front or back of the
machine are from the operating position only. Exceptions, if any, will be specified.
A. TRANSMISSION BYPASS LEVER/RODS
WARNING
Do not tow the mower, even with the bypass valves engaged.
Serious transmission damage will result from doing so.
1. Parker Transmission (if equipped) - The transmission bypass lever
is located next to the LH console to the left of the operator's seat.
When engaged the valves open a bypass within the hydrostatic
transmissions. Refer to the Set-up section for instructions on using
the bypass feature.
H I
AB
†
AA
Z2 †
X † Z1 †
if equipped
†
Figure 22
OPERATION
2. Hydro-Gear Transmission (if equipped) -
The transmission bypass rods (one for each RH
and LH transmission) are located on the rear of
the mower, below the engine. When engaged,
the two rods open a bypass within the hydrostatic transmissions, which allows
the mower to be pushed short distances by hand. Refer to the Set-up section
for additional instructions.
V
B. IGNITION SWITCH
Y †
The ignition switch is located on the RH console to the rear of the throttle control.
E †
The ignition switch has three positions as follows:
OFF/STOP — The engine and electrical system are turned off.
B
ON — The mower electrical system is energized.
D †
START — The starter motor will turn over the engine. Release the key
C
immediately when the engine starts.
NOTE: To prevent accidental starting and/or battery discharge, remove the key from
W
the ignition switch when the mower is not in use.
C. POWER TAKE-OFF (PTO) KNOB
Y †
The PTO knob is located on the RH console to the right of the
J
operator's seat.
The PTO knob operates the electric PTO clutch mounted on
the bottom of the engine crankshaft. Pull the knob upward
to engage the PTO clutch, or push the knob downward to
disengage the clutch.
The PTO knob must be in the OFF position when starting
the engine.
D. HOUR METER & SERVICE MINDER (IF EQUIPPED)
The hour meter and service minder is located on the RH console to the right of the
operator's seat. It records the hours that the mower has been operated and engine
speed (RPM) in the digital display.
Hour Meter (if equipped)
The hour meter is activated whenever the ignition
switch is turned to the ON position. Keep a record
of the actual hours of operation to assure all
maintenance procedures are completed according to the
instructions in this Operator's Manual and the Engine
Operator's Manual.
Hour Meter & Service Minder with MODE Button (if equipped)
The hour meter and service minder is activated
whenever the ignition switch is turned to the ON
position. Keep a record of the actual hours of operation
to assure all maintenance procedures are completed
according to the instructions in this Operator's Manual
and the Engine Operator's Manual. The hour meter and service minder is equipped
with a MODE button that can toggle between available functions and can be used to
reset service alerts. Press and hold the MODE button for 3 seconds while in service
alert mode or when in a service alarm mode to reset.
NOTE: When the ignition key is out of the STOP position the hourglass
is illuminated/blinks to indicate it is recording the hours of mower operation,
regardless of whether the engine is started.
13
0.0
0.0
symbol