Cub Cadet Pro Z Serie Manuel De L'utilisateur page 24

• Clean around the exhaust manifold, fuses, all wiring and harnesses, muffler pipe,
muffler shield, engine intake screens and cooling fins, etc (Figure 28).
• Clean the top of the mower deck, under the spindle covers and belt area
(Figure 29).
• Clean around and near the transmission, axle and the fan area (Figure 30 for
Parker transmissions and Figure 31 for Hydro-Gear transmissions).
Wheel Not Shown For Clarity
Wheel Not Shown For Clarity
PRODUCT CARE
Figure 28
Figure 29
Figure 30
Figure 31
• Debris can accumulate anywhere on the mower, especially on horizontal surfaces.
Additional cleaning may be necessary when mowing in dry conditions or
when mulching.
• Fuel leaks/spills, oil leaks/spills and excess lubrication can also become collection
sites for debris. Immediate repair and cleaning up oil or fuel spills can help reduce
fire hazards.
• In addition to cleaning the mower before operating and storing, do not attempt
to mow unusually tall grass (10" or higher), dry grass (e.g., pasture) or piles of dry
leaves. Dry grass or leaves may contact the engine exhaust and/or build up on the
mower deck presenting a potential fire hazard.
Storing the Mower
• Allow the machine to cool in an open area before storing.
• Do not park the mower near any flammable materials (wood, cloth or chemicals)
or any open flames or other potential source of ignition (furnace, water heater or
any other type of heater).
• Remove all combustible materials from the mower before storing. Empty cargo
boxes, grass catchers or containers.
• Always shut off fuel flow when storing or transporting if mower is equipped with
a fuel shutoff.
• Check the fuel system (lines, tank, cap and fittings) frequently for cracks or leaks.
Repair and clean as necessary.
Engine
Refer to the Engine Operator's Manual for all engine maintenance intervals,
procedures, specifications and instructions.
CHANGING THE ENGINE OIL
If the mower has been recently run, the engine, muffler, and surrounding
metal surfaces will be hot and can cause burns to the skin. Let the engine
cool for at least 5 minutes. Exercise caution to avoid burns.
Maintain oil level as instructed in Engine Operator's Manual. Be careful not to spill oil
on any of the belts.
To complete an oil change, proceed as follows:
1. Run the engine for a short time to warm the engine oil. The oil will flow more
freely and carry away more impurities. Use care to avoid burns from hot oil.
2. Locate the oil drain hose on the engine (Figure 32).
3. Remove the hose from the clip securing it to the frame.
24
WARNING
Figure 32