Connecting The Wireless Cooking Sensor To The Control Panel - Gaggenau CI 292 600 Notice D'utilisation

3.
Press down all over the surface of the silicone patch,
including in the center.
The adhesive requires 1 hour to fully cure. Do not use or
clean the pot during this time.
Notes
Do not leave the pot with the silicone patch to soak in
▯
soapy water for long periods of time.
If the silicone patch comes off, replace it with a new
▯
one.
Attaching the wireless cooking sensor
Place the cooking sensor squarely onto the silicone
patch.
Notes
Make sure that the silicone patch is completely dry
▯
before attaching the wireless cooking sensor.
Position the cookware in such a way that the wireless
▯
cooking sensor is pointing towards the outer side of
the cooktop.
To prevent overheating, the wireless cooking sensor
▯
must not be pointed towards another item of cookware
that is hot.
Remove the wireless cooking sensor from the
▯
cookware after cooking. Store it in a clean, safe place
away from sources of heat.
You can use up to three wireless cooking sensors at
▯
the same time.
Connecting the wireless cooking sensor
to the control panel
Before first use of the boiling sensor function, the
connection must be established between the wireless
temperature sensor and the control panel.
To connect the wireless temperature sensor to the
control panel, follow the instructions below:
Call up the basic setting ™†, see section
1.
The ¨ symbol lights up white.
Wireless cooking sensor
2. Press the ¨ symbol. A signal sounds and the ¨
symbol lights up orange. The burner indicators light
up white, and the boiling sensor indicators on the
burners flash.
Briefly press the ¨ symbol on the wireless
temperature sensor within 30 seconds.
3.
Detection successful: The wireless temperature sensor
is detected in a few seconds. Three short beeps will
sound, and the ¨ symbol will change from orange to
white. The boiling sensor indicators on the burners go
out.
Detection failed: Five beeps will sound. The ¨ symbol
changes immediately from orange to white, and the
boiling sensor indicators on the burners go out.
The boiling sensor functions are made available once
▯
the temperature sensor has been connected to the
control panel correctly.
If there is a fault in the temperature sensor, the
▯
connection may not be established correctly for the
following reasons:
– Bluetooth communication error.
You did not press the ¨ symbol on the
–
temperature sensor within 30 seconds of
selecting a burner.
– The battery in the temperature sensor is dead.
Reset the wireless temperature sensor and follow the
connection process once again.
If the temperature sensor and the control panel are
▯
not connected correctly due to a transmission error,
follow the connection process once again.
If no connection can be established, inform customer
service.
Resetting the wireless cooking sensor
Touch and hold the ¨ symbol for approximately 8-
1.
10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the LED
lights up for the third time, it will start to reset the
temperature sensor. At this point, you will need to lift
your finger off the symbol.
Once the LED goes out, this means that the wireless
temperature sensor has been reset.
2.
Repeat the connection process from point 2.
en-us
27