Flex Function; Cookware Use Recommendations; As Two Independent Elements; As A Single Element - Gaggenau CI 292 600 Notice D'utilisation

Flex function

You can use the flexible cooking zone as an individual
element or as two independent elements, as required.
It consists of four inductors that work independently of
each other. If the flex function is in use, only the area that
is covered by cookware is activated.

Cookware use recommendations

Place the cookware in the middle. This assures optimal
pot detection and heat distribution.

As a single element

Diameter smaller than or equal to
5 X" (13 cm)
Place the cookware on one of the
four positions that can be seen in
the illustration.
Diameter greater than 5 X"
(13 cm)
Place the cookware on one of the
three positions that can be seen in
the illustration.
If the cookware takes up more
than one element, place it starting
on the upper or lower edge of the
flexible cooking zone.

As two independent elements

The front and rear elements each have
two inductors and can be used inde-
pendently of each other. Select the
required heat setting for each of the
elements. Use only one item of cook-
ware on each element.
As two independent elements
The flexible cooking zone is used like two independent
elements.
Activating
See section ~ "Operating the appliance"
Twistpad with Twist Knob
As a single element
Using the entire cooking zone by connecting both
elements.
Linking the two elements
1.
Set down the cookware. Select one of the two
elements in the flexible cooking zone and set the heat
setting.
Touch the ª symbol. The ª indicator lights up in the
2.
cooking zone area.
The flexible cooking zone has now been activated. The
heat setting appears in the two displays for the flexible
cooking zone.
Notes
If both elements are set to different heat settings
▯
before being linked, both elements switch to 0 on
activation.
If there is a cooking timer programmed for one
▯
element, this will also be assigned to the second
element when the two are linked.
Changing the heat setting
Select one of the two elements assigned to the flexible
cooking zone and set the heat setting using the twist
knob.
Unlinking the two elements
1.
Select one of the two elements assigned to the
flexible cooking zone.
2. Touch the ª symbol.
3. The « symbol appears in the cooking zone display.
This deactivates the flexible cooking zone. The two
elements will now function independently.
Note: If the element is switched off, and then switched
back on again later, the flexible cooking zone is reset to
function as two independent elements.
en-us
21