Publicité
Les langues disponibles
Les langues disponibles
•
LPG is a petrochemical product similar to motor fuel and natural gas. It is gaseous at normal atmos-
pheric pressures and temperatures. When sufficiently pressurised, e.g. inside a gas cylinder, it is liquid.
When the pressure is released, the liquid vaporises immediately and becomes fuel gas with 250% volu-
me.
•
LPG has a similar smell to natural gas. You should be able to recognise that smell.
•
Handle "empty" gas cylinders just as carefully as full ones. Even if there is no more liquid in the gas
cylinder, there may still be pressurised gas in the apparently empty gas cylinder.
Safetyinstructionsforgashoses
Ensure that the gas hose is uncovered and not near hot areas. When the gas hose touches hot
•
areas, it may melt and leak.
•
The gas hose may not be laid directly under the fat discharge plate or the fat catcher tray.
•
Avoid twisting the gas hose unnecessarily.
Before every start-up, check the screw fixings of the gas hose connections are tight. If necessary,
•
tighten with two open-end spanners.
Before every use, check the gas hose for animal bites, cracks, porous areas, pinches, wear and
•
other damage. Replace the gas hose immediately if damaged.
•
Unlock the quick plug coupling of the side table before unfolding.
•
Only approved gas hoses may be used.
•
The maximum length of the gas hose must not exceed 1.5 metres.
•
We recommend that you replace the gas hose of your gas grill every 5 years. In some countries it is
mandatory to replace the gas hose sooner. National regulations shall take precedence.
Safetyinstructionsforthequickplugcoupling
•
All connections of the quick plug coupling must be kept free of dirt. Even slight contamination can
cause leaks at the connections. Always seal the connections with the protective cover when not in use.
•
Every time before starting the gas grill, when everything is connected and ready, check the connections
and gas corrugated pipe for leaks.
•
As some leak detector sprays, including soapy water, are possibly slightly corrosive, you must rinse all
connections with water after the leak test and dry them.
Safetyinstructionsforthegaspressureregulator
•
Make sure that the gas pressure regulator is attached so that the small air outlet faces downwards and
no water can enter the hole. This air outlet must be kept clean and free of dirt, grease, insects, etc.
•
No dirt may get into the gas pressure regulator or onto the screw fixing.
•
Before every start-up, check the screw fixings of the hose connection are tight. If necessary,
tighten with two open-end spanners.
•
Only approved pressure regulators that correspond to the national operating pressure may be used.
Obtain information from your dealer.
•
In order to guarantee proper functioning of the gas pressure regulator in normal operating conditions,
it is recommended that you replace the gas pressure regulator prior to the end of 10 years after the
date of manufacture. Deviating national regulations shall take precedence.
45
Publicité
