Publicité
Les langues disponibles
Les langues disponibles
12
©
o
o
i©
0 o s s +
o o o _
++0o +
G)_ _f_-il
!
2
oooo-I-1
1
2
Watching
the display, press the SHIFT button to select the
preset memory
block.
SHIFT
SHIFT
%
%
(Main unit)
(Remote control unit)
NOTE:
Please make sure the "AUDIO"
position of the slide
switch on the remote control unit.
Watching the display, press the PRESET UP or DOWN button
to select the desired preset channel.
CHANNEL
PRESET
(Main unit)
(Remote control unit)
!'_
LAST FUNCTION
MEMORY
• This unit is equipped with a last function memory
which stores the input and output setting conditions
as they were immediately
before the
power is switched
off.
This function eliminates
the need to perform complicated
resettings when the power is switched
on.
• The unit is also equipped with a back-up memory. This function
provides approximately
one week of memory storage when the main unit's
power switch is off and with the power cord disconnected.
INITIALIZATION
OF THE MICROPROCESSOR
When the indication
of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the
microprocessor
is required by the following
procedure.
Switch off the unit and remove
the AC cord from the wall
outlet.
Hold the following
SPEAKER A button and SPEAKER B button,
and plug the AC cord into the outlet.
Check that the entire display is flashing with
an interval of
about 1 second, and release your fingers from the 2 buttons
and the microprocessor
will be initialized.
O
°.:::1
@ o
o
o
@ _
_
o
o
@
o
o
O
o {__S_
_'_o_io
2
O
O
O
°O °
o
o
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor
has been reset, all the button settings are
reset to the default values (the values set upon shipment
from
the factory).
57
Publicité
