Publicité
Les langues disponibles
Les langues disponibles
BEFORE USING
Pay attention
to the following
before using this unit:
• Moving the set
To prevent short circuits or damaged wires in the connection cords,
always unplug the power cord and disconnect
the connection cords
between
all other audio components
when moving the set.
• Before turning the power switch on
Check once again that all connections
are proper and that there are
not problems
with the connection
cords. Always
set the power
switch to the standby position before connecting and disconnecting
connection cords.
• Store this instructions
in a safe place.
After reading, store this instructions
along with the warranty
in a
safe place.
• Note that the illustrations in this instructions
may differ from
the actual set for explanation
purposes.
• V. AUX jacks
The AVR-1804/884's front
panel is equipped with a V.
AUX jacks. Remove the cap
covering the jacks when you
want to use it.
CAUTIONS
ON INSTALLATION
Noise or disturbance
of the picture may be generated
if this unit or
any other electronic equipment
using microprocessors
is used near a
tuner or TV.
If this happens, take the following
steps:
• Install this unit as far as possible from the tuner or TV.
• Set the antenna wires from the tuner or TV away from this unit's
power cord and input/output
connection cords.
• Noise or disturbance
tends to occur particularly when using indoor
antennas or 300 £dohms
feeder wires. We recommend
using
outdoor antennas and 75 _/ohms
coaxial cables.
For heat dispersal, leave at least 10 cm of space between the top,
back and sides of this unit and the wall or other components.
4 inch!10 cm or more
Wall
I'_
CAUTIONS
ON HANDLING
• Switching
the
input
function
when
input
jacks
are
not
connected
A clicking noise may be produced if the input function
is switched
when nothing is connected to the input jacks. If this happens, either
turn down the MASTER VOLUME control or connect components
to the input jacks.
• Muting
of PRE OUT jacks, HEADPHONE
jack and SPEAKER
terminals
The PRE OUT jacks, HEADPHONE
jack and SPEAKER terminals
include a muting circuit.
Because of this, the output
signals are
greatly
reduced
for several
seconds
after the power
switch
is
turned on or input function,
surround mode or any other-set-up
is
changed. If the volume is turned up during this time, the output will
be very high after the muting circuit stops functioning.
Always wait
until the muting circuit turns off before adjusting the volume.
• Whenever
the power
switch
is in the STANDBY
state,
the
apparatus
is still connected on AC line voltage.
Please be sure to unplug the cord when you leave home for,
say, a vacation.
5
Publicité
