Publicité
Les langues disponibles
Les langues disponibles
• If another pre-main (integrated) amplifier
is connected,
the ZONE2 jacks can be used to play a different
program source in ZONE2 at the same
time.
I
I
1
Re010
RC 617
INFRARED
RETRANSMITTER
Integrated
pre=main
amplifier
INFRARED
SENSOR
OUTPU
INPUT
r DENON
"L
o © o..O..
o 0
0
0
• Connect the speaker terminals
with the speakers making sure that
like polarities are matched (@with @, @ with @). Mismatching
of
polarities will result in weak central sound, unclear orientation
of
the various instruments,
and the sense of direction
of the stereo
being impaired.
• When
making connections,
take care that none of the individual
conductors
of the speaker cord come
in contact
with
adjacent
terminals,
with other speaker cord conductors,
or with
the rear
panel.
NOTE:
NEVER touch the speaker terminals when the power is on.
Doing so could result in electric shocks.
Speaker Impedance
• When speaker systems A (]) and B (]]) are use separately, speakers
with an impedance of 6 to 16 _-dohms can be connected for use as
front and surround back/ZONE2 speakers.
• Be careful when using two pairs of front and Surround Back!ZONE2
speakers
(A + B) and (] + ]]) at the same time,
since use of
speakers with an impedance of 12 to 16 _-Z/ohms.
• Speakers with an impedance of 6 to 16 _-)./ohms can be connected
for use as center and surround speakers.
• The protector
circuit may be activated if the set is played for long
periods of time at high volumes when speakers with an impedance
lower than the specified impedance
are connected.
Connecting
the speaker cords
I. Loosen by turning
counterclockwise.
2. Insert the cord.
3. Tighten by turning
clockwise.
I. Push the lever.
2. Insert the cord.
=4>
3. Return the lever.
Connecting banana plugs
Banana plug
@
Turnclockwise to tighten, then insert the
banana plug.
16
Publicité
