Publicité
Les langues disponibles
Les langues disponibles
_'_
USING THE REMOTE
CONTROL
UNIT
Following the procedure
outlined below, insert the batteries
before using the remote control unit.
Approx. 23 feet/7 m _
\
Point the remote control unit at the remote control sensor as shown
on the diagram at the left.
NOTES:
• The remote control unit can be used from a straight distance of
approximately
23 feet/7 meters,
but this distance will shorten or
operation will become difficult if there are obstacles
between
the
remote control unit and the remote control sensor, if the remote
control sensor is exposed to direct sunlight or other strong light, or
if operated from an angle.
• Neon signs or other devices emitting
pulse-type noise nearby may
result
in malfunction,
so keep the set as far away from
such
devices as possible.
_1_Press as shown by the arrow and slide
off.
_2_Insert the R6P/AA batteries properly, as
shown on the diagram.
_3._ Close the lid.
NOTES:
• Use only R6P/AA batteries for replacement.
• Be sure the polarities are correct. (See the illustration
inside the battery compartment.)
• Remove the batteries if the remote control transmitter
will not be used for an extended period of time.
• If batteries leak, dispose of them immediately.
Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the
battery compartment
thoroughly
before installing new batteries.
• Have replacement
batteries on hand so that the old batteries can be replaced as quickly as possible when the time comes.
• Even if less than a year has passed, replace the batteries with new ones if the set does not operate even when the remote control unit is
operated nearby the set. (The included battery is only for verifying operation. Replace it with a new battery as soon as possible.)
19
Publicité
