Tunturi C85 Crosstrainer Manuel De L'utilisateur page 27

Power supply (Fig. E-1)
The trainer is powered by an external power supply� Refer to the
illustration to locate the trainer's power input�
‼ NOTE
• Connect the power supply with the trainer before connecting it to
the wall outlet�
• Always remove power cord when machine is not in use.
Console (fig F)
1� Display
2� Tablet/ book support
3� Buttons
⚠ CAUTION
• Keep the console away from direct sunlight�
• Dry the surface of the console when it is covered with drops of
sweat�
• Do not lean on the console�
• Only touch the display with the tip of your finger� Make sure that
your nails or sharp objects do not touch the display�
‼ NOTE
• The console switches to standby mode when the equipment is not
used for 4 minutes� If the console is in standby mode, the display
shows the room temperature
Explanation of buttons
BACK/ STOP
- Move back to previous window
- Stop the active training
QUICK START
- Start training without present settings�
All workout information will count up.
MAIN MENU
- It will go back to main menu�
- During training, sets console in "end your workout" mode�
USER SETTING
- Press this button to enter User/Setting mode screen
- This button is of no use during workout
MODE/ ENTER
Turn functions
- Choose workout mode in main menu
- User/setting mode option selection
- Choose working item on the setting screen
- Increase or decrease the setting value
- Adjusting target value (high/low) during workout
- Shift up or down during T-Ride™ or T-Road workout
Horizontal
- Turning clockwise to choose option rightward�
- Turning counter-clockwise for leftward
Vertical
- Turning clockwise to shift up�
- Turning counter-clockwise to shift down
Press functions:
- Sport mode confirmation
- Option confirmation under User/Setting mode
- Confirmation of working item on setting screen
- Setting value confirmation
- Screen switching between BPM-NM or BPM-W during workout
- Screen switching between BPM-M or BPM-FT during T-Ride™
- Screen switching between Video - Profile during T-Road
- Switching to next tutoring mode during T-Trainer™
External connections
USB port
Usb port can be used for:
- Service purposes such as software update�
‼ NOTE
• USB format should not be NTFS
Operation
Power on
- Press any key to power on the console when being in sleep mode��
After loading the application (fig. F-01) the user interface will be show
main menu screen (fig. F-02).
Trainer is now ready to start your workout programming or just select
quick start and begin�
Programs
Quick start
- Turn the jog wheel and select
"Quick start"
- Press the jog wheel to confirm and enter the workout screen quickly�
(fig. F-03)
The X axis denote time in minutes between 0~30� It is updated once
every 15 minutes during workout
- During workout, press the jog wheel button to switch the Y-axis
between Nm- bpm�
- The bar chart denotes torque value Nm� Rotate the jog wheel to
adjust the Nm value�
2 7
English