Kärcher KM 150/500 R D Classic Mode D'emploi page 26

Check hydraulic unit
NOTICE
Only Kärcher Customer Service is author-
ised to carry out maintenance tasks on the
hydraulic unit.
 Lock parking brake.
 Start the motor.
 Check all hydraulic hoses and connec-
tions and ensure that they are leak-
proof.
Check water cooler and maintain it
DANGER
Risk of burning and scalding!
 Allow the water cooler to cool down for
at least 20 minutes.
 Check the cooling water level on the
balance reservoir (water level between
MIN and MAX).
 Clean cooler lamella.
 Check cooler hoses and connections
and ensure that they are leak-proof.
 Clean the fan.
Checking roller brush
 Start the motor.
 Raise the waste container up to the
end-position.
 Switch off engine.
 Lock parking brake.
 Use the safety bar for emptying from a
height.
 Remove belts or cords from roller
brush.
 Remove the safety bar.
 Start the motor.
 Lower the waste container up to the
end-position.
 Switch off engine.
Replacing roller brush
1 Key
2 Side panels
 Drive the waste container up and sup-
port it with the safety rod.
 Open the side covers using a key.
26
1 Holding bow
2 Wing nut
3 Side seal
 Unscrew the wing nuts.
 Remove the retaining clamp.
 Unscrew the wingnuts from the holding
plate side seals and remove the holding
plate.
 Flip the side seal out.
 Uncscrew the retaining screw of the
roller brush intake, and swing the intake
to the outside.
 Pull out roller brush.
Installation position of roller brush in direc-
tion of travel (top view)
Note: When installing the new roller brush,
ensure correct positioning of the bristle as-
sembly.
 Install new roller brush. The nuts of the
roller brush must be inserted on the
notches of the opposite crank.
Note: Once the new roller brush has been
installed, the sweeping track must readjust-
ed.
Check and adjust roller brush sweeping
track
 Check tyre pressure.
 Switch off suction blower.
 Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
 Lower the roller brush by means of the
control lever and let it run (approx.
10 s).
 Raise roller brush.
 Drive machine backwards.
 Check sweeping mirror.
10
-
EN
The sweeping track should have an even
rectangular shape which is 80-85 mm wide.
Adjusting the sweeping level
1 Spring
2 Rating nut
3 Locknut
4 Threaded rod
 Adjust the sweeping track position by
adjusting the adjustment screw.
 Check sweeping mirror.
Check and adjust sweeping track of the
side-brush
 Check tyre pressure.
 The side-brushes lift up.
 Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
 Lower the side brushes using the con-
trol lever and allow them to run for ap-
prox. 10 seconds.
 The side-brushes lift up.
 Drive machine backwards.
 Check sweeping mirror.
The width of the sweeping track should lie
between 40-50 mm.