HOLZMANN MASCHINEN VD 1100N Mode D'emploi page 24

11.3 Residual risks
Despite their intended use, certain residual risk factors cannot be completely eliminated. Due to
the design and construction of the machine, hazardous situations may occur which are indicated
in these operating instructions as follows:
A safety instruction of this type indicates an imminently dangerous situation which, if
not avoided, will result in death or serious injury.
This type of safety information indicates a potentially dangerous situation which, if
not avoided, could result in serious injury or even death..
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in minor or moderate injury.
Such a safety notice indicates a potentially hazardous situation which, if not avoided,
may result in property damage.
Regardless of all safety regulations, your common sense and appropriate technical
suitability/training are and will remain the most important safety factor for fault-free operation of
the machine. Safe working depends on you!
12 ASSEMBLY
Heavy weight! The lathe is very heavy. Therefore, at least two or more persons and
suitable lifting equipment are required for installation, otherwise dangerous situations
can occur during installation which can result in serious injuries or even death.
12.1 Checking the scope of delivery
Visible transport damage must be noted immediately on the delivery note in
accordance with the provisions of the warranty, otherwise the goods are deemed to
be in order.
Upon receipt, check the delivery for completeness and whether all parts of the delivery are in
order. Immediately report any damage or missing parts to the freight forwarder or your retailer.
12.2 Preparatory work
12.2.1 Selecting the place of installation
Select a suitable installation location for the machine! Observe the dimensions of the machine
according to the technical specifications and the safety requirements in Chapter 11.
The place of installation must have a suitable connection to the electrical mains.
In addition, a safety distance of at least 0.8 metres must be defined around the machine.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
DANGER
WARNING
CAUTION
NOTICE
WARNING
NOTICE
ASSEMBLY
24
VD 1100N