Publicité
Les langues disponibles
Les langues disponibles
Cleaning and replacing the spark plugs (fig. 65)
Spark plugs are essential to smooth engine running and
should be checked at regular intervals.
This is done quite easily and quickly and provides a good
measure of engine condition.
Remove the spark plug caps and spark plugs from the
cylinder head using the wrench supplied with the bike.
Check the color of the insulating ceramic material of the
central electrode: a light brown, even color is a sign of
good engine condition. If color has altered or you find any
dark deposits, change the spark plug and report this to a
Ducati dealer or authorized workshop.
Check wear on the central electrode. If it looks worn out
or has a vitreous appearance, change the spark plug.
Check electrode gap: it should be 0.6-0.7 mm.
Important
If the gap needs adjusting, be very careful when
bending the side electrode. If gap is too wide or too
close, engine performance will be affected. This could
also cause difficult starting or irregular idling.
Clean the electrode and the insulating material accurately
using a small metal brush and check seal condition.
Clean the seat in the cylinder head. Be careful not to let
any foreign matters fall into the combustion chamber.
All manuals and user guides at all-guides.com
Refit spark plug into cylinder head. Snug it finger-tight
until it is fully seated into the head. Tighten the spark plug
at 20 Nm. If you do not have a torque wrench, you can
use the wrench supplied with the tool kit to tighten the
spark plug an additional 1/2 turn.
recommended or a thread length other than standard.
Spark plugs should be tightened firmly.
Important
Never use spark plugs with a heat rating other than
E
fig. 65
61
Publicité
