Bose VIDEOBAR VB1 Mode D'emploi page 3

I M P ORTA N T SA F ET Y I N STR UCT IO NS
All Bose Professional products must be installed in accordance with local, state, federal and industry regulations. It is the
installer's responsibility to ensure installation of the loudspeakers and mounting system is performed in accordance with
all applicable codes, including local building codes and regulations. Consult the local authority having jurisdiction before
installing this product.
When positioning the product, make sure it is not blocking any ventilation openings on your display. Refer to the owner's
guide for your display and install it in accordance with the manufacturer's instructions.
Do NOT make unauthorized alterations to this product.
When replacement batteries are needed, use only AAA/LR03 alkaline batteries.
The battery provided with this product may present a risk of fire, explosion or chemical burn if mishandled, incorrectly
replaced or replaced with an incorrect type. Do not recharge, disassemble, heat, or incinerate.
Keep batteries out of reach of children.
If a battery leaks, do not allow the liquid to come in contact with the skin or eyes. If contact is made, seek medical advice.
Do not expose products containing batteries to excessive heat (e.g. from storage in direct sunlight, fire or the like).
Only use the included hardware to mount this product.
Only for wall-mounting on the following surfaces: Wallboard ≥ 3/8 in (10 mm)
If mounted on surfaces other than stated above, please contact a professional installer.
The interconnect cables included with this system are not approved for in-wall installation. Please check your local
building codes for the correct type of wire and cable required for in-wall installation.
Do not mount on surfaces that are not sturdy, or that have hazards concealed behind them, such as electrical wiring or
plumbing.
Do NOT use in vehicles or boats.
Due to ventilation requirements, Bose Professional does not recommend placing the product in a confined space such as
in a wall cavity or in an enclosed cabinet.
Do not place or install the bracket or product near any heat sources, such as fireplaces, radiators, heat registers or other
apparatus (including amplifiers) that produce heat.
Keep the product away from fire and heat sources. Do NOT place naked flame sources, such as lighted candles, on or near
the product.
To reduce the risk of fire or electrical shock, do NOT expose the product to rain, liquids, or moisture.
Do NOT expose this product to dripping or splashing and do not place objects filled with liquids, such as vases, on or near
the product.
This product is not intended for installation or use in indoor water facility areas (including, without limitation, indoor
pools, indoor water parks, hot tub rooms, saunas, steam rooms and indoor skating rinks).
Do not mount the product in locations where condensation may occur.
Do NOT use a power inverter with this product.
Use this product only with the power supply provided.
Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily
operable.
|
3 E N