Bose VIDEOBAR VB1 Mode D'emploi page 22

I
To fasten the power supply cord to the wall:
1. Determine where on the wall you want to fasten the power supply cord.
2. Mark a screw hole on wall.
3. If that part of the wall has a stud behind it, drill a 2.4 mm (3/ 3 2 in) hole
into the wall.
If that part of the wall has no stud behind it, drill a 5 mm (3/ 1 6 in) hole
into the wall.
4. If that part of the wall is has no stud behind it, drive the small drywall
anchor (J) into the wall.
5. Align the eyelet of the cable tie (I) with the screw hole.
6. Drive the small flat-head screw (H) into the eyelet of the cable tie to
secure it to the wall.
SETU P
J
Small drywall anchor
K
Small flathead screw
|
2 2 E N