Bose VIDEOBAR VB1 Mode D'emploi page 29

Rear Panel
1
NETWORK
1. Network: Use this 1 Gbps RJ45 connection for configuration and/or
monitoring. (This port is on the inner side of the rear panel.)
2. Power: Connect the included power supply.
3. Audio In: Use a 3.5 mm (1/8 in) stereo cable (not included) to connect to
an optional audio source, such as the audio output from a connected
monitor or display.
4. Ctrl Input: Use the port for mute override using the included 2-pin
Euroblock connector. By default, this input is active low and includes an
internal pull-up.
5. USB-C: Connect this port to the computer hosting the meeting.
6. HDMI Display: Use the included HDMI cable to connect this port to a
display. (This port is on the inner side of the rear panel.)
Note: The host computer must have the latest DisplayLink® driver installed,
and the VB1 must have its DisplayLink setting enabled (disabled by default)
for the HDMI output to function. Visit displaylink.com/downloads to
download the latest driver. Enable or disable the DisplayLink setting using
the Videobar Configuration app or WebUI or Videobar Administration app
(see Software Applications (Page 23)).
P R OD UC T D ETA I L S
p
INPUT/输入
24V 1.875A
NETWORK
POWER AUDIO CTRL USB-C
IN INPUT TO PC
p
INPUT/输入
24V 1.875A
CTRL
POWER AUDIO
IN INPUT
2 3 4
|
2 9
HDMI DISPLAY
USB-C
TO PC
5
E N
6
HDMI DISPLAY