Yamaha WR250F Manuel D'atelier Du Proprietaire page 180

Ö Fasten the neutral switch lead and AC magneto lead.
× Pass the cylinder head breather hose on the inside of the radi-
ator hose 1 and on the outside of the radiator pipe (radiator
hose 4). Make sure that the cylinder head breather hose does
not go forward of the chassis.
Ø Pass the starter motor lead in front of the radiator hose 4.
Ù Pass the clutch cable through the cable guide.
Ú Pass the wire harness on the outside of the neutral switch lead
and AC magneto lead.
Û Fit the brake hose into the guides on the protector.
Ü Pass the wire harness, clutch cable and light switch lead
through the cable guide.
All manuals and user guides at all-guides.com
CABLE ROUTING DIAGRAM
2 - 101
Ý Fasten the AC magneto lead, neutral switch lead and light
switch lead to the cable guide at their protecting tube with a
plastic locking tie and cut off the tie end.
Þ Pass the carburetor breather hoses, carburetor overflow hose
and coolant reservoir breather hose so that the hoses do not
contact the rear shock absorber.
SPEC