Burkert 8695 Manuel D'utilisation page 45

Type 8695
AS-Interfaceinstallation
10.6.4 end position leDs
The end position is displayed optically by colored LEDs.
Figure 35: Description end position LEDs and Jumpers - AS-Interface
noTe!
Breakage of the pneumatic connection pieces due to rotational impact.
▶ When unscrewing and screwing in the transparent cap, do not hold the actuator of the process valve but the
connection housing.
Figure 36: Open control head
noTe!
Damage or malfunction due to penetration of dirt and humidity.
▶ To observe degree of protection IP65 / IP67, screw the transparent cap in all the way.
Factory setting:
color
green LED on
yellow LED off
Table 11: Assignment of LEDs - AS-Interface
10.6.5 Jumper function
You can set the color assignment of the end positions with the jumpers.
You can indicate for each color whether it applies to the Top (end position top) or Bot (end position bottom).
All manuals and user guides at all-guides.com
End position LED green
Jumper
for assignment of end position LEDs
End position LED yellow
Transparent cap
Body casing
Connection housing
Actuator
Device status
End position bottom
End position top
english
45