Burkert 8695 Manuel D'utilisation page 37

Type 8695
Electricalinstallation24VDC
→
Using the jumpers, assign the required color to the end position LEDs.
Figure 26: Description end position LEDs and Jumper - 24 V DC
noTe!
Breakage of the pneumatic connection pieces due to rotational impact.
▶ When unscrewing and screwing in the transparent cap, do not hold the actuator of the process valve but the
connection housing.
Damage or malfunction due to penetration of dirt and humidity.
▶ To observe degree of protection IP65 / IP67, screw the transparent cap in all the way.
→
Close the device (assembly tool: 674078
Figure 27: Close control head
The assembly tool (674078) is available from your Bürkert sales office.
5)
All manuals and user guides at all-guides.com
End position LED green
Jumper for
assignment of end
position LEDs
End position LED yellow
).
5)
Transparent cap
Body casing
Connection housing
Actuator
Jumper setting 1:
Top Bot
In the end position top (Top),
ye ye
the yellow LED is lit; in the
gn gn
end position bottom (Bot),
the green LED is lit.
Bot Top
Jumper setting 2:
Top Bot
In the end position top (Top),
ye
ye
the green LED is lit; in the
gn gn
end position bottom (Bot),
Bot Top
the yellow LED is lit.
english
37